Pyramix 6.2 SP2 Servisní příručka stáhnout pdf (Strana 14)

System Information

6.5.28. Autodesk recommends upgrading only if you are currently running IRIX version 6.5.19f

or above, as this is a non-destructive upgrade. Otherwise, perform a full installation of IRIX

6.5.28.

To install IRIX 6.5.28, you require the following SGI CDs:

• IRIX 6.5.28 Installation Tools and Overlays (1 of 3) August 2005—P/N 812-0818-028

• IRIX 6.5.28 Overlays (2 of 3) August 2005—P/N 812-0819-028

• IRIX 6.5.28 Overlays (3 of 3) August 2005—P/N 812-0817-028

• IRIX 6.5 Applications August 2005—P/N 812-0877-028

• IRIX 6.5 Foundation 1—P/N 812-0759-002

• IRIX 6.5 Foundation 2—P/N 812-0760-002

• ONC3/NFS version 3, for IRIX 6.2, 6.3, 6.4, and 6.5—P/N 812-0774-002

Make sure that your CDs match this list precisely. If you do not have the correct CDs, contact

your SGI support representative.

For IRIX upgrade and full installation procedures, see the IRIX 6.5.28 Installation Guide.

DKU Version Requirement

The 2007 SP5 release of your Effects or Editing application requires version 2.1.4 of the DKU.

You must perform a DKU upgrade, since previous releases use an earlier version of the DKU.

For more information about upgrading the DKU on your workstation, see “Installing the

Discreet Kernel Utility” in the Autodesk Effects and Editing 2007 Linux RHEW 4(Update2 or

Update 3) Installation and Configuration Guide.

Hardware System Requirements

Linux workstations —

This release fully supports all previously certified Linux workstations.

However, some minor changes in video I/O connections or BIOS revision may be required if

you are upgrading from a pre-2007 version of your Effect or Editing application. Consult these

Release Notes and the Hardware Setup Guide for your workstation for information on BIOS

requirements, connection to audio/video I/O hardware and other peripherals.

SGI workstations —

This release fully supports the Octane2™ V12, Tezro™, Onyx2® (R12K),

Onyx 350, and Onyx 3200 workstations. No changes in hardware configuration are required.

For specifications, you can consult your existing documentation or download the Hardware

Setup Guide for your workstation at www.autodesk.com/discreet-documentation.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 37 38

Žádné komentáře

Pyramix 6.2 SP2 Servisní příručka Strana 14